Ganter - Swing clamp, with screw-in thread, clamping arm with threaded hole
Available in 10 variations
Available in 10 variations
- Kolbendurchmesser: 25 mm - 63 mm
- d1: 14 mm - 20 mm
- :
Variant table
available in 10 variations
There is currently no further information available on this article.
Swing clamps are used when the clamping point must be freely accessible from above for inserting and removing the workpiece. The design allows a particularly space-saving installation. The height of the swing clamp can be adjusted by means of the screw-in thread. During the clamping process, a 90° swivel stroke movement downwards takes place first, followed by the linear clamping stroke. The workpiece may only be clamped within the clamping stroke. The angular position of the clamping arm can be set as desired when mounting it on the swing clamp. When tightening the screw, the piston rod must not experience any torque, therefore the clamping arm must be held against rotation.
Specifications
- : 25
- : 28
- : 170
- Type: L, linksschwenkend
- : 70
- : 74
- : 122
- : 14
- : 18
- : L, linksschwenkend
There is currently no further information available on this article.
There is currently no further information available on this article.
Zu diesem Artikel sind aktuell keine technischen Zeichnungen verfügbar
There aren't any asked questions yet.