Ganter - Sockets for square tube, aluminium
Available in 13 variations
Variant table
available in 13 variations
There is currently no further information available on this article.
Sockets are mounted by hammering them in using a soft-face hammer. The lamellas bridge a manufacturing tolerance of the inner diameter or inner square of ±0.5 mm. This enables the assembly of screws in tubes. The dimensions are based on construction tubes, but a check of the tolerance position of the tube is recommended.
Specifications
- : D20 / V20
- : V 20
- : 2
There is currently no further information available on this article.
There is currently no further information available on this article.
Zu diesem Artikel sind aktuell keine technischen Zeichnungen verfügbar
There aren't any asked questions yet.